Details
part # 2708-0060
sleeve anchors flat head zinc plated
size: 3/8"
length: 5"
box qty: 50
zinc plated, length of sleeve makes anchor more forgiving than a wedge anchor and induces less stress on the substrate, can be used in solid or hollow masonry, works in any depth hole, required hole diameter equals anchor diameter,flat head
installation: drill hole depth 1/2" to 1" deeper than anchor embedment. select a carbide tip drill bit with same nominal diameter as anchor body. Set nut flush with top of anchor and drive anchor through material to be anchored into the work surface until nut and washer are snug with material to be attached. Tighten nut until finger tight, then turn 3 to 4 full turns to set the expansion sleeve.